.png)
Our Product
.jpg)
Instructions
Step 1 - Remove Motor Cap
●Use wrench to take off axle nut and axle washer●Leave the wheel on for now
●Use the 3 mm hex wrench to remove and recycle the two black motor cap screws●Remove motor cap
Step 2 - Remove Wheel and Belt
●Loosen the 4 motor screws on your motor mounts exactly a quarter turn until the motor can slide freely up and down the motor mount●Pull off the wheel, drive pulley and drive belt●Never fully remove the motor screws
Step 3 - Replace Wheel and Belt
●Take new belt from your kit●Place belt around the drivetrain of your wheel●Place your wheel around the axle●Pulling the belt back over your motor sprockets●
Step 4 - Retension your Belt
●To tighten your belt, place your thumb against the wheel and place your fingers on the motor●Pull the motor towards the motor driver away from the axel till the belts are taunt●Take the 3 mm t-handle hex wrench and tighten the two screws farthest from the wheel first, then the two closest to it●Test the belt tension as it should be firm
●Replace axle washer and nut, tighten with wrench
Step 5 - Replace Motor Cap
●Replace the motor cap over the motor and use the 3 mm hex tool to install two NEW motor cap screws which have already been applied with blue anti-vibration thread lock
Repeat on the other side
